◀ maker
 

Double Gimbal Drink Holder: NEVER Spill Your Root Beer by EricYoung

Okay pay attention because this is very important. This thing holds your drink without spilling until you press the button to take a sip.

The PDF drawing at the bottom of the downloads section has all Assembly Instructions and a Bill of Materials that lists parts needed and their quantities. There are versions for both Metric and Imperial screws. Print the Holder, Button and Button Plug with 100% infill and the Handles with about 33% infill. I had to disable retracts while printing the Button. Your printer should hold a tolerance of about .010" if you want this thing to work properly, and you'll probably have to clean up the parts a little bit after printing to get it working smoothly. Harder materials are better for reducing the effects of friction, so if you have some

Go To Source
comments powered by Disqus
25 Jul
buxtor @buxtor
“@bre: Never spill root beer again!!! http://t.co/5ugy4Q4sak” #gimbels
24 Jul
Bre Pettis @bre
Never spill root beer again!!! http://t.co/ekfEibI4cS